Cable length: 1.0m.
Weight: 0.23kg.
Definition 1: conductor by one or a plurality of mutually insulated and insulating protective layer made of,
A conductor of electricity or information from one place to another.
Definition 2: usually by a few or several groups (each with at least two wires) cable rope twisted the similar,
Each group of wires are insulated from each other, and are often twisted around a center,
The entire outer bread has a highly insulated cover MITSUBISHI FA-TB16XYPN3 FA-TB16XYPN3
The cable has the characteristics of internal power and external insulation. Can be isolated to obtain DC24/48/100V, AC100/200V input signal.Can be isolated to obtain DC24/48/100V, AC100/200V input signal.AnyWireASLINK master station MITSUBISHI FA-TB16XYPN3.
Transmission distance: the longest 200m.
Data input and output: up to 512 points.
Connect up to 128 units.
Enter 256 points, 256 points out of the output.
Connecting the input and output of the sensor to the programmable controller.
Ultra small sensor can be freely configured to control the input and output of 512 points.
In addition, the sensor can be supplied with a AnyWireASLINK transmission line (2 lines) by means of communication,
So as to facilitate additional sensor MITSUBISHI FA-TB16XYPN3.
And can also be through the engineering software Works2 GX batch management sensor disconnection detection and from the station module settings, etc.,
Can significantly reduce the engineering hours.
Basic composition.
AnyWireASLINKAnyWireASLINK can be selected according to the load current of 2 wire or 4 wire from the station module.
In addition to the 2 wire type, the local power supply can be connected with the 4 wire type mixed use.
2 wire type.
TThe load current is less than that of the hour, by using the non isolated 2 wire type from the station module,
Easy connection without using local power supply FA-TB16XYPN3.
4 wire type
By using isolated 4 wire type from the station module, the locaal power supply can be used,
Can support the use of more current load FA-TB16XYPN3. Convert connectors to e-CON.The connector is converted to a screw relay terminal.