LK Automation Limited LK Automation Limited
Brand: MITSUBISHI
Go Back >> Product Catalogues
FX2N-48SW | MITSUBISHI Modular FX2N-48SW
MITSUBISHI FX2N-48SW Manual And Instructions
FX2N-48SW datasheetPDF datasheet
FX2N-48SW USER'S GUIDE

MITSUBISHI FX2N-48SW Product information and technical parameters:
Brand: MITSUBISHI
Name: Modular
Model: FX2N-48SW

Input points: 8 points.
Output points: 6 points.
Power supply voltage: AC100-240V.
Output type: relay output.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series MITSUBISHI FX2N-48SW.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0 FX2N-48SW5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Power supply: 110mA DC5V (PLC internal power supply), 80mA DC24V (through the power connector by the external power supply).
Analog input points: 4 points.
Voltage input: DC-10~10V MITSUBISHI FX2N-48SW.
Current input: DC-20~20mA, 4~20mA.
Weight: 0.2kg.
Dimensions: 55 x 90 x 87.
Voltage input and current input of 4 channels can be carried out,
Each channel can be specified as a current input or voltage input.
Built in digital filter function and peak hold function, etc.,
Achieved a high speed of 500 AD S/ch conversion.
FX3UC-4AD can be connected to the FX3GC or FX3UC series. Output points: 32 points MITSUBISHI FX2N-48SW.
Output form: transistor.
Connected programmable logic controller: FX1NC, FX2NC, FX3UC.
Weight: 0.2KG.
FX2NC expansion module can be directly connected to the FX1NC, FX2NC, PLC FX3UC on the expansion of the input and output.
Do not need to connect the cable and so on, therefore can carry on the compact expansion. Max input / output points: 14 points.
Supply voltage: 100 - 240VAC.
Input points: 8 points.
Output points: 6 points.
Output type: Transistor (source).
Power consumption (W): 19.
Weight (kg):0.3.
Size (WxHxD) mm:60x90x75.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control ssystem for a simple manipulator FX2N-48SW.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and caan be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX2N-48SW.


...More relevant models >>>>