LK Automation Limited LK Automation Limited
Brand Sort: MITSUBISHI
Home >> Price
A1SD61 Market price | A1SD61 Introduction
  • Brand: MITSUBISHI
  • Country: JAPAN
  • Name: High speed counting module
  • Model: A1SD61
  • Price: U.S.$ 1052.54
MITSUBISHI A1SD61
For FXCPU direct connection.3C-2V/5C-2V coaxial cable.
Double circuit.
MELSECNET (II) (remote I/O station).
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system A1SD61
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc.. DC input points: 32 points.
Input voltage and current: 3/7mA, DC12/24V.
Response time: 10ms.
Positive pole sharing.
16 point /1 a public side.
Output points: 24 points.
Output voltage and current: DC12/24V, 0.5A/1 point, 3.2A/1 common end.
Response time: 2ms.
8 point /1 a public end, 4 point /1 a public end.
Output form: transistor output, leakage type.
36 point terminal table * 2.
Number of stations: 8 stops.
Compact remote I/O unit.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
A1SD61 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=A1SD61&select=5


...more relevant model market price >>>>
Related products
MITSUBISHI
Relay output module
A1SY18AEU
MITSUBISHI Relay output module A1SY18AEU
Output type: relay. Output points: 8 poi
MITSUBISHI
output module
A1SY10
MITSUBISHI output module A1SY10
Output type: relay. Output points: 16 po
MITSUBISHI
Input module
A1SX40
MITSUBISHI Input module A1SX40
Type of input: DC leakage. Input points: