LK Automation Limited
Brand:
MITSUBISHI
GT1675M-VTBA | MITSUBISHI 10.4 inch touch screen GT1675M-VTBA
MITSUBISHI GT1675M-VTBA Manual And Instructions
GT1675M-VTBA datasheetPDF datasheet
GT1675M-VTBA User's Manual
GT1675M-VTBA MES Interface Function Manual
GT1675M-VTBA Gateway Functions Manual
GT1675M-VTBA Extended/Option Functions Manual
GT1675M-VTBA Mitsubishi plc ConnectionsConnection Manual
GT1675M-VTBA Connection Manual
MITSUBISHI GT1675M-VTBA Product information and technical parameters：
Brand: MITSUBISHI
Name: 10.4 inch touch screen
Model: GT1675M-VTBA
Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities).
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system must, or use dry cloth touch screen on the surface of the water.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the connection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it.
...More relevant models >>>>
GT1675M-VTBA datasheetPDF datasheet
GT1675M-VTBA User's Manual
GT1675M-VTBA MES Interface Function Manual
GT1675M-VTBA Gateway Functions Manual
GT1675M-VTBA Extended/Option Functions Manual
GT1675M-VTBA Mitsubishi plc ConnectionsConnection Manual
GT1675M-VTBA Connection Manual
MITSUBISHI GT1675M-VTBA Product information and technical parameters：
Brand: MITSUBISHI
Name: 10.4 inch touch screen
Model: GT1675M-VTBA
Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities).
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system must, or use dry cloth touch screen on the surface of the water.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the connection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it.
For GOT multipoint connection.
Applicable models: GT15, GT16, GT11, GT10, GT27, GT25, GT23, GT21. Clock data, alarm records, and data backup batteries (for replacement).
Applicable models: GT11, HandyGOT, GT10. A series of high performance models that are widely used in network or single machine work environments MITSUBISHI GT1675M-VTBA.
Screen size: 12.1 inches.
Display color: 256 color or more color GT1675M-VTBA
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment MITSUBISHI GT1675M-VTBA.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system MITSUBISHI GT1675M-VTBA.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly. Cable length: 1.5m.
For the connection between FXCPU and GOT.
Connection between a power supply and an operating switch and a GOT.
Applicable model: HandyGOT. Protective film for 15 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. Series Name: A951GOT.
Size: 6 inches.
Resolution: 320 * 240.
Display device: STN monochrome display.
Display color: monochrome (white and black).
Power supply: DC24V.
Built in BUS Q communication interface.
Memory card: 3M.
China is the world''s biggest market for human machine interface,
But it is not the highest sales market in the world,
This shows that the low-end user interface in China has a large share of.
In recent years, the rapid development of national brands, to take a low price and other strategies, is a massive attack on the low end of the market,
Hass occupied the dominant position in the low-end market, has won the recognition of the majority of users GT1675M-VTBA.
International brands are also gradually developing its economic products, in order to seize the share of the low-end market.
Thereefore, in the low-end market steady,
The overall performance of the domestic human machine interface manufacturers showing a rapid growth of the state GT1675M-VTBA.
Applicable models: GT15, GT16, GT11, GT10, GT27, GT25, GT23, GT21. Clock data, alarm records, and data backup batteries (for replacement).
Applicable models: GT11, HandyGOT, GT10. A series of high performance models that are widely used in network or single machine work environments MITSUBISHI GT1675M-VTBA.
Screen size: 12.1 inches.
Display color: 256 color or more color GT1675M-VTBA
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment MITSUBISHI GT1675M-VTBA.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system MITSUBISHI GT1675M-VTBA.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly. Cable length: 1.5m.
For the connection between FXCPU and GOT.
Connection between a power supply and an operating switch and a GOT.
Applicable model: HandyGOT. Protective film for 15 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. Series Name: A951GOT.
Size: 6 inches.
Resolution: 320 * 240.
Display device: STN monochrome display.
Display color: monochrome (white and black).
Power supply: DC24V.
Built in BUS Q communication interface.
Memory card: 3M.
China is the world''s biggest market for human machine interface,
But it is not the highest sales market in the world,
This shows that the low-end user interface in China has a large share of.
In recent years, the rapid development of national brands, to take a low price and other strategies, is a massive attack on the low end of the market,
Hass occupied the dominant position in the low-end market, has won the recognition of the majority of users GT1675M-VTBA.
International brands are also gradually developing its economic products, in order to seize the share of the low-end market.
Thereefore, in the low-end market steady,
The overall performance of the domestic human machine interface manufacturers showing a rapid growth of the state GT1675M-VTBA.
...More relevant models >>>>