LK Automation Limited LK Automation Limited
Brand Sort: MITSUBISHI
Home >> Price
QX40-TS Market price | QX40-TS Introduction
  • Brand: MITSUBISHI
  • Country: JAPAN
  • Name: Type DC input module (spring clip connector)
  • Model: QX40-TS
  • Price: U.S.$ 364.41
MITSUBISHI QX40-TS
Protective film for 5.7 inch screen.
Scrub, 5.
Applicable model: GT14. Length: 3m.
Specification: D-sub 25 pin (male), D-sub 25 pin (male). MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 30.0kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0 QX40-TS888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.MITSUBISHI PLC online debugging.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on step by step.
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the program can be. Number of channels: 2 channels.
Sensing method and temperature range: PT100.
A1S64TC series component is a kind of temperature controller combined with ANS series CPU.
Components with temperature measurement input and built-in PID algorithm control output, can be used in a variety of temperature control occasions.
Each component controls up to 4 loops at most.
Thermocouple input or PT100 3 wire temperature sensor input.
Control output switching signal for the output of the transistor.
BW is a signal with broken line detection function.
QX40-TS Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=QX40-TS&select=5


...more relevant model market price >>>>
Related products
MITSUBISHI
Type DC input module
QX41-S1
MITSUBISHI Type DC input module QX41-S1
Input points: 32 points. Input voltage a
MITSUBISHI
Type DC input module
QX41-S2
MITSUBISHI Type DC input module QX41-S2
Input points: 32 points. Input voltage a
MITSUBISHI
Type DC input module
QX40-S1
MITSUBISHI Type DC input module QX40-S1
Input points: 16 points. Input voltage a