LK Automation Limited LK Automation Limited
Brand Sort: MITSUBISHI
Home >> Price
QJ71FL71 Market price | QJ71FL71 Introduction
  • Brand: MITSUBISHI
  • Country: JAPAN
  • Name: FL-net module
  • Model: QJ71FL71
  • Price: U.S.$ 2720.34
MITSUBISHI QJ71FL71
The main unit of the AS-i system
The response time of PLC is the interval between the time of the change of the external output signal of the PLC and the time of the change of the external output signal which is controlled by it,
Lag time, this is the time constant of the input circuit,
The time constant of the output circuit, the arrangement of the user statement and the use of the instruction,
The cycle scan mode of PLC and the way of PLC to refresh the I/O and so on QJ71FL71
This phenomenon is called the I/O delay time effect.
Input status and input information input from the input interface,
CPU will be stored in the working data memory or in the input image register.
And then combine the data and the program with CPU.
The result is stored in the output image register or the working data memory,
And then output to the output interface, control the external drive. Cable length: 5.0m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between A7GT-CNB.
Applicable models: GT16, GT15, GT11. Protective film for 5.7 inch screen.
Scrub (frame: white), 5.
Applicable model: GT14. Power: 0.4kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor.
QJ71FL71 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=QJ71FL71&select=5


...more relevant model market price >>>>
Related products
MITSUBISHI
Modem interface module
QJ71CMON
MITSUBISHI Modem interface module QJ71CMON
"10BASE-T/100BASE-TX. "A channel modular
MITSUBISHI
Optical fiber loop (SI) module
QJ71LP21-25
MITSUBISHI Optical fiber loop (SI) module QJ71LP21-25
SI/QSI/H-PCF/ roadand H-PCF optical ca
MITSUBISHI
Serial communication module
QJ71C24-R2
MITSUBISHI Serial communication module QJ71C24-R2
"2CH RS-232. QJ71C24N -R2 through the