Interface power supply: 24VDC plus or minus 10%.
Digital input: 30 points, optocoupler isolation, drain / source type support.
Digital output: 16 points, optocoupler isolation, drain / source type support.
Analog input: 2 channels, 0 to plus or minus 10VDC (input impedance: 10~12k).
Analog output: 2 channels, 0 to plus or minus 12VDC. Life is 40000 hours, and the user can simply change the background light MR-J4-70B-RJ
Application Series: F943GOT. Function extension board for RS-232C communication.
No DC24V consumption, no occupancy of the input output (FX1S and FX1N of the host computer). Input type: DC input, positive common end.
Input points: 4 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/7mA.
Output form: transistor output, leakage type.
Output points: 4 points.
OFF leakage current: 0.1mA.
Output protection function: No.
Rated load voltage / current: DC24V/0.5A.
External connection: 3 line /2 line type.
According to the external connection mode and the external equipment input and output specifications,
Choose from a rich product lineup.
Finger protection through the upper part of the terminal,
The human body will not be exposed to live parts,
Therefore, the terminal station type remote I/O module can be directly mounted to the machine tool. Protective film for 15 inch screen.
Scrub, 5.
Applicable model: GT15. Power: 7.5kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor.
MR-J4-70B-RJ Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J4-70B-RJ&select=5