Convert connectors to e-CON.MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 15kw.
SLD converter rated current: 77A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) FX2N-16EYT datasheet PDF catalog FX2N-16EYT PDF datasheet FX2N-16EYT
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications that require high torque at low speeds, the HD rating is the most suitable FX2N-16EYT datasheet PDF catalog FX2N-16EYT PDF datasheet.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. The number of output channels: 4 channels.
Voltage output: DC-10~10V.
Current output: DC0~20mA, DC-4~20mA.
Programmable logic controller: FX2NC, FX3UC FX2N-16EYT datasheet PDF catalog FX2N-16EYT PDF datasheet.
By using analog input module and output module,
Can be input and output analog (voltage, current, etc.).
Indispensable analog control in FA control,
It is easy to implement on a programmable logic controller. Input points: 8 points.
Output points: 6 points.
Power supply voltage: AC100-240V.
Output type: relay output.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 22.0kw.
SLD converter rated current: 47A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performancee of the motor FX2N-16EYT datasheet PDF catalog FX2N-16EYT PDF datasheet.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control FX2N-16EYT datasheet PDF catalog FX2N-16EYT PDF datasheet.