Input voltage range: AC100-120V/AC200-240V.
Output voltage: DC5V.
Output current: 8A.
For Q4ARCPU.
The control module monitors the power supply, the error
CPU state,
And its own error state.
It sends out
Error signal a6raf and open the corresponding
Relay output.
I/O points is an important indicator of PLC A970GOT-TBD-B datasheet PDF catalog A970GOT-TBD-B PDF datasheet.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest
A970GOT-TBD-B
The input and output points and types of PLC should be determined according to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point.
Taking into account the future adjustment and expansion,
In general should be estimated on the total number of points plus the amount of spare 20%~30% A970GOT-TBD-B datasheet PDF catalog A970GOT-TBD-B PDF datasheet.
The following describes the centralized control system I/O points of the estimate. Input voltage range: AC100 ~ 120V.
Output voltage: DC24V.
Output current: 0.6A.
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the normally open contact is closed,
Provide load current and voltage A970GOT-TBD-B datasheet PDF catalog A970GOT-TBD-B PDF datasheet.
When the internal circuit outputs a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is disconnected from the load.
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action.
I/O points is an important indicator of PLC.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should be determined according to the analog quantity and switch quantitty of the controlled object,
Generally an input / output element to take up an input / output point A970GOT-TBD-B datasheet PDF catalog A970GOT-TBD-B PDF datasheet.
Taking into account the future adjustment and expansion,
In general should be estimaated on the total number of points plus the amount of spare 20%~30% A970GOT-TBD-B datasheet PDF catalog A970GOT-TBD-B PDF datasheet.
The following describes the centralized control system I/O points of the estimate.