Three-phase 3 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information Q68TD-G-H01 Hardware Manual Q68TD-G-H01 User's Manual Q68TD-G-H01
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment Q68TD-G-H01 Hardware Manual Q68TD-G-H01 User's Manual.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products.
For example, a module can be used to measure other loads from the control panel trunk Q68TD-G-H01 Hardware Manual Q68TD-G-H01 User's Manual.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.2 channel.
Differential input: 40kpps/400kpps/800kpps/2Mpps/4Mpps/8Mpps.
Count input signal: EIA standard RS-422-A (differential line driver).
DC input: 10kpps/100kpps/200kpps.
Count input signal: DC5/12/24V 7 ~ 10mA.
External output: DC24V.
Consistent output: Transistor (drain), DC12/24V, 0.1A/ point, 0.8A/ common.
40 pin connector.
Multifunctional counting / timing module (QD65PD2)
Very precise positioning and tracking.
Maximum count rate of up to 8Mpps (differential input 4 phase 2 frequency multiplication), is 2 times in the past.
Multifunctional and convenient use!
Pulse measuring function... Measurement resolution of 100ns, can be performed with high precision pulse measurement.
PWM output function... Configuration of the maximum 200 PWM kHz output function. Available 0.1 s single
Bit change duty cycle, to achieve ultra precise output control.
Cam switching function... Thee output of the 8 points, 16 step / output cam switch Q68TD-G-H01 Hardware Manual Q68TD-G-H01 User's Manual.
High precision timing control can be realized by cam switch.
Complete complex control using a consistent test!
Uniform output function... Caan provide support for complex applications Q68TD-G-H01 Hardware Manual Q68TD-G-H01 User's Manual.
According to the specific circumstances, choose to use the cam switch function or the same output function.