Control axis: maximum 8 axes.
Peripheral I/F: by CPU PLC.
Manual pulse generator operation function: can use 3 sets of manual pulse generator.
Synchronous encoder operation function: can use 8 synchronous encoder.
CPU special high speed communication bus, each 0.88ms cycle can exchange 14K data word Q2ACPU-S1 Special Function module Manual Q2ACPU-S1 PROGRAMMING MANUAL.
Exercise basic performance is about 2 times, sports SFC processing time is reduced by about 1/4 Q2ACPU-S1
PLC interrupt program to achieve high-speed synchronization between multiple CPU.
Motion specific instruction.Control axis: maximum 8 axes.
Greater flexibility.
PLC control and motion control using independent CPU, optimize the system configuration.
More than 4 CPU modules can be freely selected in multi CPU system Q2ACPU-S1 Special Function module Manual Q2ACPU-S1 PROGRAMMING MANUAL.
MITSUBISHI SSCNET control function.
By using the high speed serial communication mode, we can easily construct the synchronization system of the servo motor.
The motion controller and the servo amplifier can be quickly connected by a connector, and the connection is simplified.
Each 1 CPU can control up to 32 axes at the same time.
Can control the small capacity from 10W to 55KW large capacity servo motor Q2ACPU-S1 Special Function module Manual Q2ACPU-S1 PROGRAMMING MANUAL.
Through the use of digital oscilloscope function, can be used to control the power distance, speed, position and other motor information monitoring.Input / output points: 4096 points.
You can use the CF card.
Version OS:VxWorks 5.4.
Easy connection programming tool via ethernet.
Programming tools (Works2 GX, Developer GX) and CPU direct connection (1 to 1),
No need to carry out the IP address settings. And there is no need to select the cable, the straight line and the cross line can be used.
Therefore, this connection method and the use of USB, can easily communicate with the CPU,
Even the operators are not familiar with the network settings can easily establish a connection.
Easy connection through the hub CPU.
By using an Ethernet hub, programming tools and multiple CPU can be connected simultaneously.
Through the programming tool can be searched and displayed in the list has been connected to the CPU.
Therefore, even if the IP CPU address is unknown, just choose from this list, you can easily connect.
Seamless communication without network level constraints.
With the latest high-speed, large capacity IE CC-Link controller network and IE CC-Link field network,
Corresponding to thhe increasing amount of information Q2ACPU-S1 Special Function module Manual Q2ACPU-S1 PROGRAMMING MANUAL.
Together with previous MELSECNET/H, Ethernet and CC-Link,
These networks can be across the network type or level of differences, to achieve seeamless communication Q2ACPU-S1 Special Function module Manual Q2ACPU-S1 PROGRAMMING MANUAL.
Programmable logic controller on the network through the programming tool of the Ethernet connection,
Monitoring and programming.