8 slots.
Extended substrate.
Double power supply mode power supply redundancy system.
Used to install Q series modules.
Reduce system downtime recovery time.
With a simple operation, you can back up all the data in the CPU to the memory card.
Through regular backup, can be the latest parameters, procedures, etc Q26UDVCPU Common Instruction 1/2 Manual Q26UDVCPU Programming Manual. to save the storage card Q26UDVCPU
In the event of a CPU failure, after the replacement of CPU, can be a simple operation,
Restore the system by using the data storage card in advance.
Therefore, it is not necessary to spend time to manage the backup data, but also can shorten the recovery time of the system shutdown.
Wider application range, more advanced.
Leading in the era of the Q series CPU products Q26UDVCPU Common Instruction 1/2 Manual Q26UDVCPU Programming Manual.
Q series CPU products a wide range of applications,
Provide programmable controller, process, redundancy, C language, movement, manipulator, CNC all kinds of CPU,
In order to meet the needs of various control.
Through the multi CPU configuration, can be based on the use of the scale, purpose,
Construction of the best system to meet the requirements of all kinds of control.
In addition, the high reliability system can be constructed by the redundant system,
Even if a fault occurs, the system can continue to run Q26UDVCPU Common Instruction 1/2 Manual Q26UDVCPU Programming Manual. Battery replacement.
Initial voltage 3.0V.
Current capacity: 5000mAh.
Service life: 5 years.Three-phase 3 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wirre products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products Q26UDVCPU Common Instruction 1/2 Manual Q26UDVCPU Programming Manual.
For example, a module ccan be used to measure other loads from the control panel trunk Q26UDVCPU Common Instruction 1/2 Manual Q26UDVCPU Programming Manual.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.