8 slots; requires 1 AnS series PLC power modules;
Used to install large AnS series PLC module.
Base plate of AnS series PLC.
QA1S series PLC 8 slot main substrate.
AnS series of modules can be installed. Cable length 0.45 meters.
Extended substrate for connection."Maximum control axis: 2 axis.
Connection mode with servo amplifier: SSCNET III /H connection type Q04UDVCPU PID Control Instructions Manual Q04UDVCPU Programming Manual Q04UDVCPU
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 2 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network Q04UDVCPU PID Control Instructions Manual Q04UDVCPU Programming Manual .
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported Q04UDVCPU PID Control Instructions Manual Q04UDVCPU Programming Manual .
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project and the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS). "Master / local station sharing.
Corresponding Ver2 CC-Link.
Consistency of CC-Link to maintain loop transmission,
And the cycle of transmission and information (instantaneous transmission) communication separately, so as to ensure the timeliness of.
Even if the information reaches saturation, it will not affect the link scan time.
The QJ61BT11N module suupports CC-Link version 1 and version 2, which can be used as a local station or master station module Q04UDVCPU PID Control Instructions Manual Q04UDVCPU Programming Manual .
I/O control in the first class of open field network module.
CC-Link baseed on reliable field bus technology,
Able to transmit large number of bits data (such as ON/OFF information) and word data (such as analog information) Q04UDVCPU PID Control Instructions Manual Q04UDVCPU Programming Manual .