MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.1kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for linear servo motor.
Power specification: single phase AC200V.
More advanced real-time automatic tuning by setting response values,
Including the position gain and the gain of speed, all the gain can be adjusted automatically MR-J3-100T General-Purpose Interface Manual MR-J3-100T INSTRUCTION MANUAL MR-J3-100T
32 segment response level can be set.
Advanced vibration suppression control.
An optimal vibration control filter value is automatically set by the automatic tuning function to effectively suppress the vibration of the 100Hz frequency that occurs when the driving part stops.
The automatic tuning function can effectively restrain the vibration of the end of the mechanical arm and reduce the residual vibration in the machine MR-J3-100T General-Purpose Interface Manual MR-J3-100T INSTRUCTION MANUAL. MR-J2M multi axis servo amplifier expansion unit.
1, the servo controller through the automation interface can be easily carried out the operation module and the conversion of the field bus module,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J3-100T General-Purpose Interface Manual MR-J3-100T INSTRUCTION MANUAL.
2, the servo controller is directly connected with the rotary transformer or encoder, and the speed and displacement control loop is formed.
The general inverter can only form an open loop control system.
3 servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 15.0kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communication reduce wiring.
Distriibuted servo control system can be built by CC-Link communication MR-J3-100T General-Purpose Interface Manual MR-J3-100T INSTRUCTION MANUAL.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J3-100T General-Purpose Interface Manual MR-J3-100T INSTRUCTION MANUAL.
When the two stations are occupied, the speed can be set directly by the remote register.