Superior high efficiency IPM motor.
Output power: 1.5kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MELSEC-Q SERIES Application Functions Manual MELSEC-Q SERIES Programming Manual. MR-J2M multi axis servo amplifier drive unit MELSEC-Q SERIES
Rated output: 0.2kw.
AC servo control system includes AC servo system based on asynchronous motor and AC servo system based on synchronous motor.
Besides the advantages of good stability, good rapidity and high accuracy, the advantages of.
Its performance indicators can be measured from the speed range, positioning accuracy, the accuracy of stability, dynamic response and operational stability and so on MELSEC-Q SERIES Application Functions Manual MELSEC-Q SERIES Programming Manual. Multi axis integrated servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Axis number: 3 axis.
Rated output A axis (Note 1): 0.4kw.
Rated output B axis (Note 1): 0.4kw.
Rated output C axis (Note 1): 0.4kw.
Interface: SSCNET III /H.
Note the 1:A axis, B axis, C axis indicates the name of a type of multi axis servo amplifier axis MELSEC-Q SERIES Application Functions Manual MELSEC-Q SERIES Programming Manual. The C axis represents the 3 axis one type servo amplifier.
Support SSCNET III /H. 3 axis one type servo amplifier capable of driving 3 servo motors through a single module.
More energy saving, space saving, less wiring, low cost.
Inherited the high performance and high reliability.
Will, as always, adhere to and uphold the excellent quality of MELSERVO.
MR-J4 has inherited the excellent design of existing products.
Its essence to its dregs, create advantage and cost effective utilization rate,
Make full use of renewable resources, to create a new product. MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 37.0kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise.
EEven in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit MELSEC-Q SERIES Application Functions Manual MELSEC-Q SERIES Programming Manual.
It is only necessary to add a battery on the seervo amplifier, which can form the absolute value system MELSEC-Q SERIES Application Functions Manual MELSEC-Q SERIES Programming Manual.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.