MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 11KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions FX3U-64MT/ESS Manual FX3U-64MT/ESS HARDWARE MANUAL.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operated at high precision in the super low speed region without the need of the encoder FX3U-64MT/ESS
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc FX3U-64MT/ESS Manual FX3U-64MT/ESS HARDWARE MANUAL. ) and torque control. Analog input: 2.
Analog output points: 1 points.
Weight: 0.1kg.
FX3 series can be connected to the 2 channel input (voltage: DC0~10V, or current DC4~20mA), as well as 1 channel output (DC0~10V, or current: DC4~20mA) of the adapter.
Each channel can be specified as a current input or voltage input FX3U-64MT/ESS Manual FX3U-64MT/ESS HARDWARE MANUAL.
Connecting FX3SA, FX3S, FX3GA, FX3G, and FX3U main body, the need to convert the adapter or function expansion board. Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 3M. Power: 0.4kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DCC reactor FX3U-64MT/ESS Manual FX3U-64MT/ESS HARDWARE MANUAL. )
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Cable flat ccable;
Connector with 20 pin installed at both ends of the fuse FX3U-64MT/ESS Manual FX3U-64MT/ESS HARDWARE MANUAL.
Length 1.5M. Needle number: 40.
Specification: loose wire connector, 5 sets (0.3mm 2).