Convert connectors to fast connectors.
According to the location of the connection equipment distribution module. The number of output channels: 4 channels.
Voltage output: DC-10~10V.
Current output: DC0~20mA, DC-4~20mA.
Programmable logic controller: FX2NC, FX3UC.
By using analog input module and output module,
Can be input and output analog (voltage, current, etc FX2N-64MR-ES/UL Manual FX2N-64MR-ES/UL PROGRAMMING MANUAL II FX2N-64MR-ES/UL ).
Indispensable analog control in FA control,
It is easy to implement on a programmable logic controller. Maximum frequency: 200kHz.
Input points: 2 points.
Output form: transistor 4 point output.
Weight: 0.2kg.
1 FX3U-2HC can enter the 2CH high speed signal, can achieve the maximum count of 200kHz.
Through the comparison of the value of the PLC set, each ch with 2 points of high-speed output terminal FX2N-64MR-ES/UL Manual FX2N-64MR-ES/UL PROGRAMMING MANUAL II.
In the 2 phase count, can be set 1, 2, 4 frequency.
Can be achieved by PLC or external input to count the licensing / prohibition.
Can also be connected to the linear drive output type of the encoder.
FX3UC host connected to the FX2NC-CNV-IF, the need for FX3U-2HC or FX3UC-IPS-5V. Input points: 8 points.
Output points: 6 points FX2N-64MR-ES/UL Manual FX2N-64MR-ES/UL PROGRAMMING MANUAL II.
Power supply voltage: AC100-240V.
Output type: relay output.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Function extension board for RS-232C communication.
No DC24V consumption, no occupancy of the input output (FX1S and FX1N of the host computer). Power: 160kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Power: 0.75kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75KK) and above capacity and above capacity FX2N-64MR-ES/UL Manual FX2N-64MR-ES/UL PROGRAMMING MANUAL II.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motorr power used to select the DC reactor FX2N-64MR-ES/UL Manual FX2N-64MR-ES/UL PROGRAMMING MANUAL II.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)