MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 37kw.
SLD converter rated current: 77A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
The motor efficiency is not changed in the previous optimal excitation control,
At the same time, the newly developed advanced optimal excitation control can obtain larger torque at startup FX1S-14MT-DSS Manual FX1S-14MT-DSS HARDWARE MANUAL FX1S-14MT-DSS
No need to adjust the parameters (plus deceleration time or torque, etc.), in a short time to speed up to a certain speed,
Can be carried out to maximize the efficiency of energy-saving drive motor.
The automatic tuning function of the loop constant of the motor is not consistent with the constant of the motor, the motor of other manufacturers, and the length of wiring is too long,
Optimum operating characteristic drive motor FX1S-14MT-DSS Manual FX1S-14MT-DSS HARDWARE MANUAL.
In the state of the sensor can not only drive the high efficiency and energy saving motor and PM motor (MM-EFS), but also can drive other companies induction motor and PM motor (permanent magnet synchronous motor).
Other manufacturers of induction motors, can also be automatically tuned to achieve the best excitation control, thus expanding the use of energy saving FX1S-14MT-DSS Manual FX1S-14MT-DSS HARDWARE MANUAL. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 0.75kw.
SLD converter rated current: 7.7A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station.
Buillt in 2 PID arithmetic FX1S-14MT-DSS Manual FX1S-14MT-DSS HARDWARE MANUAL. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine.
No external PID controller is used to control the externnal machine, so the system cost can be reduced FX1S-14MT-DSS Manual FX1S-14MT-DSS HARDWARE MANUAL. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.