Screw, 2 piece type terminal.
Voltage output module.
Number of channels: 4 channels.
Number of stations: 2 stops.
Station type: remote equipment station.
High speed data transfer of up to 10Mbps;
The development of CC-LINK is not only to meet the control of high speed remote I/O,
But also to meet the high speed of the field of information control A985GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A985GOT-TBA-EU Operating Manual A985GOT-TBA-EU
In order to achieve this goal, the transmission speed of CC-LINK is compared with that of the previous live network system to add 40 to 10Mbps.
Such a high speed can not affect the speed of the machine control while allowing a large number of data communication. DC input points: 16 points.
Input voltage and current: 3/7mA, DC12/24V.
Response time: 10ms A985GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A985GOT-TBA-EU Operating Manual.
16 point /1 a public side.
Positive pole sharing.
Output points: 12 points.
Output voltage and current: DC24V/AC240V, 2A/1 point, 5A/1 common end.
Response time: 12ms.
8 point /1 a public end, 3 point /1 a common end, independent contact.
Output form: relay output.
36 point terminal station.
Number of stations: 4 stops.
Compact remote I/O unit.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program A985GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A985GOT-TBA-EU Operating Manual.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too guarantee the timeliness A985GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A985GOT-TBA-EU Operating Manual A985GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A985GOT-TBA-EU Operating Manual.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.