32 point connector for compression connector (37 pin D-sub connector).Cable length: 35 meters.
For QCPU and GOT (need A9GT-QCNB) connection.
For the connection between GOT and GOT. DC input points: 64 points.
Input voltage and current: 4/9mA, DC12/24V.
Response time: 107ms.
Positive pole sharing.
16 point /1 a public side A975GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A975GOT-TBA-EU Operating Manual A975GOT-TBA-EU
Output points: 64 points.
Output voltage and current: DC12/24V, 100mA/1 point, 2A/1 common end.
Response time: (2I/O update time * 5) Ms.
32 point /1 a public side.
Output form: transistor output, leakage type.
40 pin connector x 4.
Number of stations: 4 stops.
Compact remote I/O unit.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program A975GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A975GOT-TBA-EU Operating Manual.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add A975GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A975GOT-TBA-EU Operating Manual.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Output type: transistor output, drain type.
Output points: 16 points.
OFF leakage current: 0.25mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.5A.
External connection: 2 wire.
According to the external connection mode and the external equuipment input and output specifications,
Choose from a rich product lineup A975GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A975GOT-TBA-EU Operating Manual.
Finger protection through the upper part of the terminal,,
The human body will not be exposed to live parts,
Therefore, the terminal station type remote I/O module can be directly mounted to the machine tool A975GOT-TBA-EU SW4D5C-GOTR-PACKE compatible Extended/Option Functions Manual Manual A975GOT-TBA-EU Operating Manual.