SRAM memory card.
RAM capacity: 64KB. Master station.
Support DB A20 AnyWire system.
DB A20 AnyWire system uses a separate transmission mode,
Sensor networks to achieve high speed and high reliability.
The transmission distance of 50m/200m/1km/3km can be selected.
1 modules can be up to 512 points of the input, 512 points of output (standard setting) Q4MCA-4MBS datasheet PDF catalog Q4MCA-4MBS PDF datasheet Q4MCA-4MBS
Even branch wiring, but also to detect transmission lines.Control axis: maximum 32 axes.
Teaching running function: there (when using SV13).
To stop the speed control function at the specified location.
The servo motor can rotate at a predetermined speed,
After starting the specified location to stop the instruction,
Can be set in advance to stop the location Q4MCA-4MBS datasheet PDF catalog Q4MCA-4MBS PDF datasheet.
You can change the speed by changing the value of the options at the time of the operation,
You can also change the acceleration / deceleration time.
Phase compensation function.
The mixed function of virtual mode and real mode.
Smooth clutch linear acceleration / deceleration function.Axis of control: 16.
Compact Q170MCPU integrated power supply module, PLC and motion controller,
And built in the packaging equipment used in the incremental synchronous encoder signal and signal detection signal required for the interface,
Do not need to add the appropriate module Q4MCA-4MBS datasheet PDF catalog Q4MCA-4MBS PDF datasheet.
Reduce the design cost of the system expansion!
Although the structure is compact, but as a motor controller based on the iQ platform of MITSUBISHI motor,
Q170MCPU as an independent motion controller, also has high performance and easy to use.Three-phase 4 wire type.
Measuring circuit number: 3 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products Q4MCA-4MBS datasheet PDF catalog Q4MCA-4MBS PDF datasheet.
For example, a module ccan be used to measure other loads from the control panel trunk Q4MCA-4MBS datasheet PDF catalog Q4MCA-4MBS PDF datasheet.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.