Uses: MR-BAT6V1SET-A, MR-BT6VCASE use.Drive: MR-H_ACN series CC-LINK features.
Rated output: 1.0KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MR-J3-20BS datasheet PDF catalog MR-J3-20BS PDF datasheet.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data MR-J3-20BS Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J3-20BS datasheet PDF catalog MR-J3-20BS PDF datasheet.
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive. MITSUBISHI general purpose AC servo amplifier MR-J2 series MR-J3-20BS datasheet PDF catalog MR-J3-20BS PDF datasheet.
Rated output: 1.0kw.
Interface: general purpose interface.
Voltage: three phase AC200V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control.
By installing a personal computer with a servo setting software, the parameters setting, trial run, state display, and gain adjustment are performed.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of the MITSUBISHI servo system,
The control modes are position control, speed control and torque control, as well as the switching control mode among them MR-J3-20BS datasheet PDF catalog MR-J3-20BS PDF datasheet. Superior high efficiency IPM motor.
Output power: 1.5kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the poower frequency power MR-J3-20BS datasheet PDF catalog MR-J3-20BS PDF datasheet.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time.