MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 11.0kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0 MR-J2S-40CP1-S084 datasheet PDF catalog MR-J2S-40CP1-S084 PDF datasheet. 888ms MR-J2S-40CP1-S084
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise MR-J2S-40CP1-S084 datasheet PDF catalog MR-J2S-40CP1-S084 PDF datasheet.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.Purpose: MR-JE-B MR-J2S-40CP1-S084 datasheet PDF catalog MR-J2S-40CP1-S084 PDF datasheet. Drive: MR-H_ACN series CC-LINK features.
Rated output: 3.5KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system iis relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J2S-40CP1-S084 datasheet PDF catalog MR-J2S-40CP1-S084 PDF datasheet.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-J2S-40CP1-S084 datasheet PDF catalog MR-J2S-40CP1-S084 PDF datasheet.