Can be isolated to obtain DC24/48/100V, AC100/200V input signal.Max input / output points: 30 points.
Supply voltage: 100 - 240VAC.
Input points: 16 points.
Output points: 14 points.
Output type: Transistor (source).
Power consumption (W): 21.
Weight (kg):0.45.
Size (WxHxD) mm:100x90x75.
All equipment is digital input and output point FX3U-80MT/DSS datasheet PDF catalog FX3U-80MT/DSS PDF datasheet FX3U-80MT/DSS
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 FX3U-80MT/DSS datasheet PDF catalog FX3U-80MT/DSS PDF datasheet.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment. Power: 75kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode FX3U-80MT/DSS datasheet PDF catalog FX3U-80MT/DSS PDF datasheet.
Equipped with standard power retrogradation function. Function: CPU module (internal service power supply).
Input and output points: 32 points.
Power supply capacity (DC5V power): 900mA.
Power supply capacity (DC24V service power supply): 400mA.
Input / output mode: DC24V (drain / source) / relay output.
Input points: 16 points.
Output points: 16 points.
The new expansion module is more convenient!
Pioneer products with advanced built-in functions and rich extensibility.
FX5U built-in analog, communication, high speed input and output,
By extending the board and adapter can be easily extended system.
In addition, through the high speed system bus,
Can maximize the role of the built-in intelligent functions of the expansion device.
Power: 0.4kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is neceessary to take protective measures and cooling FX3U-80MT/DSS datasheet PDF catalog FX3U-80MT/DSS PDF datasheet.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FX3U-80MT/DSS datasheet PDF catalog FX3U-80MT/DSS PDF datasheet.
The installation of thermal relay, to avoid overheating and burn the braking resistor.