Output points: 32 points
Output form: Transistor (source).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FR-D720S-0 FR-D720S-0.4K4K datasheet PDF catalog FR-D720S-0.4K PDF datasheet. Input output cable for A6TBXY36 type connector / terminal row conversion module.
Length 5M. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.The largest input / output points: 30 points.
Power supply voltage: 24VDC.
Input points: 16 points FR-D720S-0.4K datasheet PDF catalog FR-D720S-0.4K PDF datasheet.
Output points: 14 points.
Output type: Transistor (source).
Power consumption (W): 8.
Weight (kg):0.35.
Size (WxHxD) mm:100x90x49.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator FR-D720S-0.4K datasheet PDF catalog FR-D720S-0.4K PDF datasheet.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment.MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 280KW.
The main circuit of the inverter can be divided into two categories in general: voltage type is the voltage source of the DC converter for AC inverter,
The filtering of the DC circuit is the capacitance; the current mode is the DC conversion of the current source to the AC inverter,
The DC loop filter is the inductor.
Why is the frequency of the inverter voltage proportional to the change?
The electromagnetic torque of any motor is the result of the interaction between the current and the magnetic flux, the current is not allowed to exceed the rated value, otherwise it will cause the heating of the mmotor FR-D720S-0 FR-D720S-0.4K datasheet PDF catalog FR-D720S-0.4K PDF datasheet. 4K datasheet PDF catalog FR-D720S-0.4K PDF datasheet.
Therefore, if the magnetic flux decreases, the electromagnetic torque will decrease, which leads to the reduction of the load carrying capacity.