Q3MEM-8MBS, Q3MEM-4MBS replacement battery.Control axis: maximum 8 axes.
Teaching operation function: No.
To stop the speed control function at the specified location.
The servo motor can rotate at a predetermined speed,
After starting the specified location to stop the instruction,
Can be set in advance to stop the location Q172CPUN-T Common Instructions Manual Q172CPUN-T Programming Manual.
You can change the speed by changing the value of the options at the time of the operation,
You can also change the acceleration / deceleration time Q172CPUN-T
Phase compensation function.
The mixed function of virtual mode and real mode.
Smooth clutch linear acceleration / deceleration function."Maximum control axis: 16 axis.
Connection mode with servo amplifier: SSCNET III /H connection type Q172CPUN-T Common Instructions Manual Q172CPUN-T Programming Manual.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms, 1.77ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 16 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network Q172CPUN-T Common Instructions Manual Q172CPUN-T Programming Manual.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring.
In addition to positioniing control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc Q172CPUN-T Common Instructions Manual Q172CPUN-T Programming Manual. .
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q172CPUN-T Common Instructions Manual Q172CPUN-T Programming Manual. "