Three-phase 3 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information Q12PRHCPU Structured Text(ST) Manual Q12PRHCPU PROGRAMMING Guide Book
Q12PRHCPU
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment Q12PRHCPU Structured Text(ST) Manual Q12PRHCPU PROGRAMMING Guide Book.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products.
For example, a module can be used to measure other loads from the control panel trunk Q12PRHCPU Structured Text(ST) Manual Q12PRHCPU PROGRAMMING Guide Book.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.Control axis: maximum 8 axes.
Peripheral I/F: by CPU PLC.
Manual pulse generator operation function: can use 3 sets of manual pulse generator.
Synchronous encoder operation function: can use 8 synchronous encoder.
CPU special high speed communication bus, each 0.88ms cycle can exchange 14K data word.
Exercise basic performance is about 2 times, sports SFC processing time is reduced by about 1/4.
PLC interrupt program to achieve high-speed synchronization between multiple CPU.
Motion specific instruction.Control axis: maximum 8 axes.
Teaching running function: there (when using SV13).
Greater flexibility.
PLC control and motion control using independent CPU, optimize the system configuration.
More than 4 CPU modules can be freely selected in multi CPU system.
MITSUBISHI SSCNET control function.
By using the high speed serial communication mode, we can easily construct the synchronization system of the servo motor.
The motion controller and the servo amplifier can be quickly connected bby a connector, and the connection is simplified Q12PRHCPU Structured Text(ST) Manual Q12PRHCPU PROGRAMMING Guide Book.
Each 1 CPU can control up to 32 axes at the same time.
Can control the small capacity from 10W to 55KW large capacity servo motoor Q12PRHCPU Structured Text(ST) Manual Q12PRHCPU PROGRAMMING Guide Book.
Through the use of digital oscilloscope function, can be used to control the power distance, speed, position and other motor information monitoring.