"10BASE-T/100BASE-TX.
Web servo module for RS-232.
Web server module capable of using Internet / Intranet for remote monitoring and operation of programmable controller.
Use the Internet connected to the PC, just through a simple setup,
Remote monitoring / operation of MELSEC from any location.
Data recording function can be used to display and collect data Q04UDEHCPU Special Instructions Manual Q04UDEHCPU Programming Manual Q04UDEHCPU
Data can be recorded at the shortest distance of 100ms.
Also has the following functions.
Using email to send data / alarm notification.
Using FTP to transfer / access data files.
The display function of event monitor / history record.
User authentication /IP filter and other security features.
User can customize the creation of Web pages Q04UDEHCPU Special Instructions Manual Q04UDEHCPU Programming Manual. ""Maximum control axis: 4 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network Q04UDEHCPU Special Instructions Manual Q04UDEHCPU Programming Manual.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring.
In addition to positioniing control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc Q04UDEHCPU Special Instructions Manual Q04UDEHCPU Programming Manual. .
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q04UDEHCPU Special Instructions Manual Q04UDEHCPU Programming Manual. "