Type: general purpose AC servo amplifier MR-E series.
Rated output: 1.0kw.
Interface type: analog input interface.
KH003 special mark for Super MR-E.
Servo amplifier terminals are used to reduce the required wiring time.
The connector is located in front of the servo amplifier, which is convenient for cable connection MR-J3ACN Manual MR-J3ACN Installation Instructions.
The gain adjustment can be easily carried out by the real-time automatic tuning function MR-J3ACN
Wide use.
Machining equipment and machine tool feed.
Used for food, packaging equipment and feeding device.
For textile machinery, etc..
Can improve the performance of equipment. The length of the line: 2M.
Relay type.
IP level: IP20.
Bending life: high bending life.
Encoder with cable (amplifier side); for HF-KP/HF-MP series MR-J3ACN Manual MR-J3ACN Installation Instructions. MR-J3-BS by installing security logic unit MR-J3-D05, can be achieved to stop class 1 (SS1) function.
STO and SS1 features of the security level of IEC/EN 61508 SIL 2, SILCL2 EN62061 and ISO 13849-1 EN PL D (3 categories).
MR-J3- - BS - standard connection diagram.
When using MR-J3-D05.
The connection mode is different from the supply voltage.
Main circuit / control circuit power supply connection MR-J3ACN Manual MR-J3ACN Installation Instructions. Superior high efficiency IPM motor.
Output power: 2.2kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. A power supply connector set for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor electromagnetic brake.
For MR-J2S-11KA (4) MR-J2S-22KA to (4). Drive unit 200VAC/400VAC level.
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series.
Need conversion unit MR-J3-CR55K4) supporting the use of.
Rated output: 30kw.
Interface type: SSCNET type III fiber communication.
Special features: integrated driver security.
Power specification: three phase AC400V.
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0.44ms communication cycle,
A fully synchronous control system can be constructed.
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring.
Due to the adoption of the optical fiber communication, the anti noise ability can be ggreatly improved and the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized MR-J3ACN Manual MR-J3ACN Installation Instructions.
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable foor mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties MR-J3ACN Manual MR-J3ACN Installation Instructions.