1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 11.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC400V.
0.6kW and 1kW above the servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication MR-J2S-700B4 Manual MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL MR-J2S-700B4
Can be combined with the servo system controller to maximize the performance of the servo system.
Improve mechanical properties by high performance motor.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higher precision and better performance of rotation.
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment MR-J2S-700B4 Manual MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL.
Easily start advanced seismic function, it can maximize the mechanical properties.
It can automatically adjust the required response settings automatically. The length of the line: 10M.
IP level: IP65.
Bending life: standard.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction) MR-J2S-700B4 Manual MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 7.0KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. Type: MR-C type.
Symbol 10A for motor models: HC-PQ033/053/13.
Power supply voltage: single phase AC220V.
Drive: servo drive in the development of the premise of the frequency conversion technology,
Current loop in the drive,
Speed loop and position loop (frequency converter without the ring) have carried out a more precise control than the general frequency control technology and algorithm,
In function is also a lot stronger than the traditionnal servo,
The main point can be precise position control MR-J2S-700B4 Manual MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL.
The control speed and position are controlled by the pulse sequence transmitted by the upper controller,
The internal algorrithm of the driver and the faster and more accurate calculation and better performance of electronic devices to make it more superior to the inverter MR-J2S-700B4 Manual MR-J2S-700B4 SUPPLEMENTARY INSTRUCTION MANUAL.