MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 15.0kw.
Interface type: SSCNET type III fiber communication.
Power specification: three phase AC400V.
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0.44ms communication cycle,
A fully synchronous control system can be constructed MR-H-E02 Manual MR-H-E02 Instruction Manual MR-H-E02
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring.
Due to the adoption of the optical fiber communication, the anti noise ability can be greatly improved and the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized MR-H-E02 Manual MR-H-E02 Instruction Manual.
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable for mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties. The length of the line: 2M.
IP level: IP65.
Direct type.
Bending life: high bending life.
The cable is not shielded MR-H-E02 Manual MR-H-E02 Instruction Manual.
Electric motor power supply cable for HF-KP/HF-MP series (motor shaft with side extraction). "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 2.0kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Link
Simply setting the point table.
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and display can also be transmitted through the CC-Link.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "MR-J2M multi axis servo amplifier substrate.
Groove position: 4.
The comparison is to compare the input command signal with the feedback signal of the system in order to obtain the deviation signal between the output and the input,
Usually implemented by a dedicated circuit or computer MR-H-E02 Manual MR-H-E02 Instruction Manual.
The controller is usually a computer or PID control circuit, and its main task is to transform the deviation signal from the output of the comparator,
To control the execution of components as required MR-H-E02 Manual MR-H-E02 Instruction Manual.