Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-L represents bending life. Specification: allowed regeneration power: 500W, resistance value: 13 ohm.
Uses: MR-JE-200B, MR-JE-300B, MR-JE-200A, MR-JE-300A with. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MR-C-T01 Manual MR-C-T01 Installation Guide.
Rated output: 15 MR-C-T010kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: three phase AC400V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder MR-C-T01 Manual MR-C-T01 Installation Guide.
MR-J3-B-RJ006 can be used in conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements. ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system.
Flexible system configuration.
Can achieve higher load side positioning accuracy!The length of the line: 5M MR-C-T01 Manual MR-C-T01 Installation Guide.
Relay type.
IP level: IP20.
Bending life: standard.
Encoder with cable (amplifier side); for HF-KP/HF-MP series. Superior high efficiency IPM motor.
Output power: 30kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. When using MR-J2CN1 connectors.
RS-422 communication cable is provided by the customer. Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-L represents bending life.
Fiber length: 0.15 meters.
SSCNET III cables (standard optical fiber used in control cabinet).
Joints for CN1A and CN1B. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 2.0KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-C-T01 Manual MR-C-T01 Installation Guide.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop ccontrol system MR-C-T01 Manual MR-C-T01 Installation Guide.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter.