Accessories for 8.4 inch models.
Applicable models: GT16, GT15. Cable length: 1m.
Can be used when the GT15-C / EXSS-1 and GT15-C / BS combination.
Applicable models: GT16, GT15, GT11. 8.4 inches.
Applicable models: GT27, GT25, GT23. 12.1 inches.
Surface treatment: anti reflective film.
Protective film color: No GT2710-VTBA-GF Non-Mitsubishi Products 2 Manual GT2710-VTBA-GF Connection Manual.
USB protection cover parts: there is an opening GT2710-VTBA-GF
Set number: 5.
Applicable models: GT27, GT25. Cable length: 30 meters.
FXCPU GOT.
FXCPU communication function expansion board GOT.
[MINI-DIN 8 pin loose line (row 5 pin interface terminal)].
Applicable model: GT21. For video input (NTCS/PAL) 4 channel / RGB input 1 channel composite input.
Applicable model: GT16. Support for 10.4 inch /8 GT2710-VTBA-GF Non-Mitsubishi Products 2 Manual GT2710-VTBA-GF Connection Manual. 4 inch.
Applicable models: GT16, GT15. Support for 15 inch.
Applicable models: GT16, GT15. Cable length: 30 meters.
QnACPU GOT.
RS-422 conversion (FA-CNV / CBL) cable GOT.
The serial communication module GOT.
The peripheral machine connection module (AJ65BT-G4-S3) GOT.
[D-sub 25 pin loose line (row 5 pin interface terminal)].
GT2103-PMBD does not support Q00JCPU, Q00CPU, CPU Q01CPU direct connection GT2710-VTBA-GF Non-Mitsubishi Products 2 Manual GT2710-VTBA-GF Connection Manual.
Applicable model: GT21. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system.
In order to ensure the norrmal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2710-VTBA-GF Non-Mitsubishi Products 2 Manual GT2710-VTBA-GF Connection Manual GT2710-VTBA-GF Non-Mitsubishi Products 2 Manual GT2710-VTBA-GF Connection Manual.