RS-232 to RS422 conversion unit (RS-422 connector: 25-pin).
Applicable models: GT15, GT16. Cable length: 3m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21 GT2512F-STNA Manual GT2512F-STNA SAFETY PRECAUTIONS. Cable length: 0.7m.
For the connection between QnAS/AnSCPU/ motion controller A7GT-CNB (A Series) and CPU GT2512F-STNA
Applicable models: GT16, GT15, GT11. For analog RGB output 1ch (slim module).
Applicable model: GT27. Cable length: 10m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21 GT2512F-STNA Manual GT2512F-STNA SAFETY PRECAUTIONS. RS-422/485 serial communication unit (D-sub9 pin (header).
Applicable models: GT15, GT16, GT27, GT25. Protective film for 10.4 inch screen.
Scrub, 5.
Applicable model: GT15. Cable length: 10m.
The connection between the FXCPU (MINI-DIN8 pin connector) and the graphic operation terminal.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT GT2512F-STNA Manual GT2512F-STNA SAFETY PRECAUTIONS.
Applicable models: GT10, GT21. Cable length: 1m.
Connection between a power supply unit (A0J2-PW) and a graphic operation terminal for A0J2HCPU.
Applicable models: GT16, GT15, GT11. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen systemm GT2512F-STNA Manual GT2512F-STNA SAFETY PRECAUTIONS.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2512F-STNA Manual GT2512F-STNA SAFETY PRECAUTIONS.