Total input and output points: 32 points.
Input points: 16 points.
Output points: 16 points.
Output type: relay output.
Power supply voltage: AC100-240V.
Input signal voltage: DC24V.
8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0.08 S/ basic instructions FX3U-64MT/ES-A Basic & Applied Instructions Edition Manual FX3U-64MT/ES-A PROGRAMMING MANUAL FX3U-64MT/ES-A
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable FX3U-64MT/ES-A Basic & Applied Instructions Edition Manual FX3U-64MT/ES-A PROGRAMMING MANUAL.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).
Note recording function, Component annotation can be recorded in the program register FX3U-64MT/ES-A Basic & Applied Instructions Edition Manual FX3U-64MT/ES-A PROGRAMMING MANUAL.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program. Max input / output points: 14 points.
Power supply voltage: DC24V.
Input points: 8 points.
Output points: 6 points.
Output type: relay.
Power consumption (W): 19.
Weight (kg):0.3.
Size (WxHxD) mm:60x90x75.
Positioning and pulse output functions: a PLC cell can output 2 point 100KHz pulses at the same time.
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute or relative address expression and special pulse output control.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, caan be output 2 100KHz pulse, direct drive servo or stepper motor FX3U-64MT/ES-A Basic & Applied Instructions Edition Manual FX3U-64MT/ES-A PROGRAMMING MANUAL.
The series PLC can not be brought with the expansion module, but can be installed by the BBD board to extend a small amount of I/O FX3U-64MT/ES-A Basic & Applied Instructions Edition Manual FX3U-64MT/ES-A PROGRAMMING MANUAL.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.