Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.Input and output points: 24 points.
Power supply: DC24V.
Input points: 14 points.
Output points: 10 points.
Output form: transistor output (drain).
Power consumption: 21W.
Weight: 0.55KG.
Outline dimension: 90x90x86mm FX2N-80MR-D Manual FX2N-80MR-D PROGRAMMING MANUAL II.
FX3GE on the performance of the FX3GA increased analog input / output and Ethernet communication and other built-in features FX2N-80MR-D
Applicable to a wide variety of applications.
Basic unit: 24/40 point.
Third generation standard model.
High flexibility.
Suitable for small scale control of high cost PLC.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points FX2N-80MR-D Manual FX2N-80MR-D PROGRAMMING MANUAL II.
A versatile PLC.
Built in CPU, power supply, input and output, analog input and output, Ethernet port, can be used immediately after the purchase.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. MITSUBISHI inverter series: FR-F840 FX2N-80MR-D Manual FX2N-80MR-D PROGRAMMING MANUAL II.
Voltage level: three phase 400V.
Power: 2.2kw.
SLD converter rated current: 5.2A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 90KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes.
For the requirements of relatively high precision, even if the load changes are also required to operate aat a given speed of the occasion,
Inverter with PG feedback function can be used (selection) FX2N-80MR-D Manual FX2N-80MR-D PROGRAMMING MANUAL II.
If the given acceleration time is too short, the output frequency of the inverter is far more than thhe change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FX2N-80MR-D Manual FX2N-80MR-D PROGRAMMING MANUAL II.