MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 7.5kw.
SLD converter rated current: 17.0A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed FX1S Series Manual FX1S Series PROGRAMMING MANUAL II.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption FX1S Series
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control FX1S Series Manual FX1S Series PROGRAMMING MANUAL II. Power supply: 110mA DC5V (PLC internal power supply), 80mA DC24V (through the power connector by the external power supply).
Analog input points: 4 points.
Voltage input: DC-10~10V.
Current input: DC-20~20mA, 4~20mA.
Weight: 0.2kg.
Dimensions: 55 x 90 x 87.
Voltage input and current input of 4 channels can be carried out,
Each channel can be specified as a current input or voltage input FX1S Series Manual FX1S Series PROGRAMMING MANUAL II.
Built in digital filter function and peak hold function, etc.,
Achieved a high speed of 500 AD S/ch conversion.
FX3UC-4AD can be connected to the FX3GC or FX3UC series. Power: 15kw.
Voltage: 400V.
There are 100% braking torque output in continuous regeneration, which can correspond to the continuous regeneration operation of the pipeline control.
There is no need to install the braking unit for each frequency converter, which can reduce the comprehensive space and reduce the comprehenssive cost FX1S Series Manual FX1S Series PROGRAMMING MANUAL II.
Renewable energy can be used for other frequency converter, excess energy back to the grid, to achieve energy saving. Purpose: to operate, monitor, and change the parameters through thhe network FX1S Series Manual FX1S Series PROGRAMMING MANUAL II.
Applicable frequency converter: FR-A700, FR-F700, FR-E700. Output extension board (transistor output 2 point)
(FX1S and FX1N host general).