MITSUBISHI inverter FR-E720 series.
Voltage level: 3 phase 200V.
Frequency converter capacity: 3.7KW.
In order to ensure the reliability of production, all production machinery in the design of power with drive, there is a certain amount of surplus.
When the motor can not run under full load, in addition to meet the requirements of power driven,
The surplus torque increases the active power consumption, resulting in the waste of electric energy FX1N-40MR-D Manual FX1N-40MR-D PROGRAMMING MANUAL II FX1N-40MR-D
Speed control method of fan and pump equipment traditional by regulating the entrance or exit of the baffle, valve opening to regulate air flow and water flow
, the input power is large, and a large amount of energy consumption in the baffle, the valve in the process of closure FX1N-40MR-D Manual FX1N-40MR-D PROGRAMMING MANUAL II.
When using variable frequency control, if the flow rate is reduced, the speed of the pump or fan can be reduced to meet the requirements. Output points: 16 points.
SCR output type. MITSUBISHI inverter FR-A720 series.
Voltage level: 3 phase 200V.
Frequency converter capacity: 90KW.
Inverter general area of domestic enterprises to occupy more than 80% of the market share,
Production of frequency converter, motor soft starter and other industrial automation control of the manufacturers, the use of heavy-duty design products,
Overload capacity, with super large start and running capacity, improve the automatic detection, protection and control performance,
Can start and control any type of heavy duty motor,
Products have been widely used in metallurgy, mining, paper, chemicals, building materials, machinery, electricity, and construction systems and other industrial transmission areas FX1N-40MR-D Manual FX1N-40MR-D PROGRAMMING MANUAL II. Needle number: 40.
Specification: loose wire connector, 5 sets (0.3mm 2). Maximum frequency: 50kHz.
Input points: 1 points.
Output form: transistor 2 point output.
Weight: 0.13kg.
FX2NC-1HC can achieve high speed counting by 11 phase /2 phase 50kHz hardware counter FX1N-40MR-D Manual FX1N-40MR-D PROGRAMMING MANUAL II.
Hardware comparator with high speed matching output function.
In the 2 phase count, can be set 1, 2, 4 frequency.
Can be achieved by PLC or external inputt to count the licensing / prohibition FX1N-40MR-D Manual FX1N-40MR-D PROGRAMMING MANUAL II.
Can also be connected to the linear drive output type of the encoder.
FX2NC-1HC can only be connected to FX3UC.