Power: 75kw.
Voltage: 200V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Convert connectors to e-CON.Input points: 14 points.
Output points: 10 points FR-F740-37K-CHT Applied Manual FR-F740-37K-CHT Instruction manual.
Power supply voltage: AC100-240V FR-F740-37K-CHT
Output type: relay output.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory FR-F740-37K-CHT Applied Manual FR-F740-37K-CHT Instruction manual.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Function: bus conversion FX5 (connector) - FX3.
Input and output points: 8 points.
Conversion module connecting FX3 series expansion module.
FX3 series expansion module, only the right side of the bus conversion module can be connected. MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V FR-F740-37K-CHT Applied Manual FR-F740-37K-CHT Instruction manual.
Power: 5.5kw.
SLD converter rated current: 34A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight).
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications tthat require high torque at low speeds, the HD rating is the most suitable FR-F740-37K-CHT Applied Manual FR-F740-37K-CHT Instruction manual.
The controller is used to control and monitor the frequency converter through the network.
Standard corressponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps FR-F740-37K-CHT Applied Manual FR-F740-37K-CHT Instruction manual. DOS/V computer (D-SUB 9 pin)