Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 3M. Power: 45kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the motor power used to select AC reactor FR-D720-2.2K BASIC Manual FR-D720-2.2K Instruction manual.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose FR-D720-2.2K) Power: 7.5kw.
Voltage: 400V.
There are 100% braking torque output in continuous regeneration, which can correspond to the continuous regeneration operation of the pipeline control.
There is no need to install the braking unit for each frequency converter, which can reduce the comprehensive space and reduce the comprehensive cost FR-D720-2.2K BASIC Manual FR-D720-2.2K Instruction manual.
Renewable energy can be used for other frequency converter, excess energy back to the grid, to achieve energy saving. MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 2.2KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions FR-D720-2.2K BASIC Manual FR-D720-2.2K Instruction manual.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operated at high precision in the super low speed region without the need of the encoder.
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc.) and torque control. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 5.5kw.
SLD converter rated current: 34A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also througgh the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FR-D720-2.2K BASIC Manual FR-D720-2.2K Instruction manual.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FR-D720-2.2K BASIC Manual FR-D720-2.2K Instruction manual.
No external PID controller is used to control the external machine, so the system cost can be reduced.