Power: 22kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FR-A840-02160-2-60 DETAILED Manual FR-A840-02160-2-60 Instruction manual FR-A840-02160-2-60
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FR-A840-02160-2-60 DETAILED Manual FR-A840-02160-2-60 Instruction manual.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Output points: 16 points.
SCR output type. Input / output form: relay output.
Output points: 16 points.
Input and output points: 16 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure FR-A840-02160-2-60 DETAILED Manual FR-A840-02160-2-60 Instruction manual.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansiion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FR-A840-02160-2-60 DETAILED Manual FR-A840-02160-2-60 Instruction manual.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FR-A840-02160-2-60 DETAILED Manual FR-A840-02160-2-60 Instruction manual.
The number of connection points depends on the basic unit and the expansion unit.